Solvente y solubilidad |
In Vitro:
DMSO : 25 mg/mL (87.65 mM; Need ultrasonic; Hygroscopic DMSO has a significant impact on the solubility of product, please use newly opened DMSO)
Preparing Stock Solutions
Concentration
Solvent
Mass
|
1 mg |
5 mg |
10 mg |
1 mM
|
3.5059 mL
|
17.5297 mL
|
35.0594 mL
|
5 mM
|
0.7012 mL
|
3.5059 mL
|
7.0119 mL
|
10 mM
|
0.3506 mL
|
1.7530 mL
|
3.5059 mL
|
View the Complete Stock Solution Preparation Table
*
Please refer to the solubility information to select the appropriate solvent. Once prepared, please aliquot and store the solution to prevent product inactivation from repeated freeze-thaw cycles. Storage method and period of stock solution: -80°C, 6 months; -20°C, 1 month. When stored at -80°C, please use it within 6 months. When stored at -20°C, please use it within 1 month.
Calculadora de molaridad
Calculadora de dilución
Mass (g) = Concentration (mol/L) × Volume (L) × Molecular Weight (g/mol)
Concentration (start) × Volume (start) = Concentration (final) × Volume (final)
This equation is commonly abbreviated as: C1V1 = C2V2
In Vivo:
Select the appropriate dissolution method based on your experimental animal and administration route.
For the following dissolution methods, please ensure to first prepare a clear stock solution using an In Vitro approach and then sequentially add co-solvents:
To ensure reliable experimental results, the clarified stock solution can be appropriately stored based on storage conditions. As for the working solution for in vivo experiments, it is recommended to prepare freshly and use it on the same day.
The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution. If precipitation or phase separation occurs during preparation, heat and/or sonication can be used to aid dissolution.
-
Protocol 1
Add each solvent one by one: 10% DMSO 40% PEG300 5% Tween-80 45% Saline Solubility: ≥ 2.5 mg/mL (8.76 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown). Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 400 μL PEG300, and mix evenly; then add 50 μL Tween-80 and mix evenly; then add 450 μL Saline to adjust the volume to 1 mL. Preparation of Saline: Dissolve 0.9 g sodium chloride in ddH₂O and dilute to 100 mL to obtain a clear Saline solution.
-
Protocol 2
Add each solvent one by one: 10% DMSO 90% (20% SBE-β-CD in Saline) Solubility: ≥ 2.5 mg/mL (8.76 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown). Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 900 μL 20% SBE-β-CD in Saline, and mix evenly. Preparation of 20% SBE-β-CD in Saline (4°C, storage for one week): 2 g SBE-β-CD powder is dissolved in 10 mL Saline, completely dissolve until clear.
-
Protocol 3
Add each solvent one by one: 10% DMSO 90% Corn Oil Solubility: ≥ 2.5 mg/mL (8.76 mM); Clear solution
This protocol yields a clear solution of ≥ 2.5 mg/mL (saturation unknown). If the continuous dosing period exceeds half a month, please choose this protocol carefully. Taking 1 mL working solution as an example, add 100 μL DMSO stock solution (25.0 mg/mL) to 900 μL Corn oil, and mix evenly.
For the following dissolution methods, please prepare the working solution directly.
It is recommended to prepare fresh solutions and use them promptly within a short period of time.
The percentages shown for the solvents indicate their volumetric ratio in the final prepared solution.
If precipitation or phase separation occurs during preparation,
heat and/or sonication can be used to aid dissolution.
-
Protocol 1
Add each solvent one by one: 50% PEG300 50% Saline Solubility: 5 mg/mL (17.53 mM); Suspended solution; Need ultrasonic
In Vivo Dissolution Calculator
Please enter the basic information of animal experiments:
Please enter your animal formula composition:
Recommended: Keep the proportion of DMSO in working solution below 2% if your animal is weak.
The co-solvents required include: DMSO,
. All of co-solvents are available by MedChemExpress (MCE).
, Tween 80. All of co-solvents are available by MedChemExpress (MCE).
|
Referencias |
-
[1]. Liang YB, et al. Downregulated SOCS1 expression activates the JAK1/STAT1 pathway and promotes polarization of macrophages into M1 type. Mol Med Rep. 2017 Nov;16(5):6405-6411.
[Content Brief]
[2]. Sanhes L, et al. Fludarabine-induced apoptosis of B chronic lymphocytic leukemia cells includes early cleavage of p27kip1 by caspases. Leukemia. 2003 Jun;17(6):1104-11.
[Content Brief]
[3]. Frank DA, et al. Fludarabine-induced immunosuppression is associated with inhibition of STAT1 signaling. Nat Med. 1999;5(4):444-447.
[Content Brief]
[4]. Frank DA,et al. Fludarabine-induced immunosuppression is associated with inhibition of STAT1 signaling. Nat Med. 1999 Apr;5(4):444-7.
[Content Brief]
[5]. Tournilhac O, et al. Impact of frontline fludarabine and cyclophosphamide combined treatment on peripheral blood stem cell mobilization in B-cell chronic lymphocytic leukemia. Blood. 2004 Jan 1;103(1):363-5. Epub 2003 Sep 11.
[Content Brief]
[6]. Weiss L, et al. Fludarabine in combination with cyclophosphamide decreases incidence of GVHD and maintainseffective graft-versus-leukemia effect after allogeneic stem cell transplantation in murinelymphocytic leukemia. Bone Marrow Transplant. 2003 Jan;31(1):11-5.
[Content Brief]
|